System Construction; Outputting To A Rgb Monitor; To Control By A Computer - Canon RE-350 Instruction Manual

SYSTEM CONSTRUCTION

4
The RE-350 has abundant video input and output terminals.The equipment shown below can be connected
to these terminals. Use the specified power cord. For other cords, use commercially available cables. For
details of operation, refer to the instruction manual of the equipment to be used.
Output Equipment
Video monitor
To AUDIO IN
BNC
video
cable
RCA pin
cable
AUDIO VIDEO
OUT
R L
IN
RCA pin
cable
BNC video cable
To AUDIO OUT
VC-C1
Input Equipment
Computer
VCR
Video camera,
speakers with an
amplifier, etc.
To VIDEO IN To S-VIDEO IN
S-video
cable
S VIDEO RGB OUT EXIT
R G
SYNC
ON 75 OFF
B
ON SYNC OFF
S-video cable
To VIDEO OUT To S-VIDEO OUT
VCR
VIZCAM 1000
Video camera
RGB monitor
RGB projector
RGB cable
BNC video cable
Rear panel
RS-232C AC OUTLET
AC INLET
24/96
100/60
ID 0
ID 1
1 0
RS-232C cable
Computer
To control certain functions of the RE-350 by a computer, complete
the following steps:
Connect the RE-350 to the computer using a RS-232C cable.
Set the electronic shutter, communication speed and ID number.
Turn ON the power to the equipment.
Operate the computer.
For details, please consult Canon U.S.A.
Outputting to a RGB
monitor
To output to a RGB monitor,
connect the RE-350 to a
monitor with RGB input terminal
using a commercially available
RGB cable. If using a RGB
monitor without a SYNC
terminal, set the
selection switch to ON. The
RGB monitor projects pictures
via the camera
regardless of the selection of
input equipment.
Video camera, VC-C1,
VCR, VIZCAM1000, etc.
To 120VAC
power outlet
Power cord
For connecting power cords
to Video camera, VC-C1, VCR,
VIZCAM1000,etc.(up to 5A in total)

To control by a computer

E
SYNC
head,
16