Rear Panel - Canon RE-350 Instruction Manual

Rear Panel

See page 16 for system construction.
AUDIO OUT terminals (stereo)
VIDEO OUT terminal
OUT
IN
AUDIO IN terminals (stereo)
Terminator selection switch
Set this switch to ON when external
synchronization signal must be
terminated (see page 19).
SYNC selection switch
Set this switch to ON to add synchronization
signal to G signal when using an RGB monitor
(see page 16). When the switch is set to OFF,
synchronization signal will be output to the
SYNC terminal of the RGB OUT terminals.
Right Side Panel
MIC IN jack
Microphone volume control knob
7
S-VIDEO OUT terminal
RGB OUT terminals
AUDIO VIDEO S VIDEO RGB OUT
R
R L SYNC
B
S-VIDEO IN terminal
VIDEO IN terminal
ON 75Ω OFF
ON SYNC OFF
(see page 17)
MIC LEVEL
External synchronization input terminal
RS-232C terminal
AC outlet
EXIT RS-232C AC OUTLET
G
ON 75Ω OFF
24/96
100/60
ID 0
ON SYNC OFF ID 1
1 0
24/96
100/60
ID 0
ID 1
1 0
ID number
setting switch
Set this switch when
controlling the RE-
350 by a computer.
If the screen flickers, change the setting of this selector.
MEMO
Screen flicker is caused mainly by fluorescent lamps and
tends to occur in the areas where power frequency is 50
Hz. Factory default is set to 1/60.
• In areas where the power frequency is 50 Hz, set it to
1/100.
• In areas where the power frequency is 60 Hz, set it to
1/60.
Use to adjust external synchronization (see page 19).
Hue (sub carrier)
Hue fine-adjustment volume
Horizontal phase adjustment volume
1 2 3 4
H
SC
MIC
PHASE
(See page 19)
Use this terminal when controling the RE-350
by a computer (see page 16, 20).
Should not exceed 5A. This outlet is not
interlocked.
AC INLET
AC inlet
Communication speed selector
Set this switch for communication with a
computer. (Left: 2400 bps, right: 9600 bps).
Electronic shutter speed selector
Set this switch when the screen flickers
(Left: 1/100 sec, right: 1/60 sec).
selector