Advertisement
4 port x4 lanes (Advanced mode)
Connect the correspond ports as shown in the right diagram.
After booting up Falcon 4010,
Go to GUI→Port Configuration
Set the host port to 4x4 mode before power on the host machines.
Host 1
0
Host 2
0
Host 3
0
Host 4
0
Host 1 will be recognized as 1:H1.0
Host 2 will be recognized as 1:H1.1
Host 3 will be recognized as 1:H1.2
Host 4 will be recognized as 1:H1.3
If your HBA (host side) is installed in different directions, make sure you connect the
cables to the right connectors.
Failure to follow the cabling order may result in system error.
-
Chassis
-
0
-
Chassis
-
1
-
Chassis
-
2
-
Chassis
-
3
9
Advertisement
