Leadtek Quadro Series General Manual page 8

Hardware Installation
4
Step
Fasten the mounting bracket to the chassis.
5
(Only for Quadro products with 6-pin or 8-pin connector)
Step
6
Plug the cord into the matched connector of the
Step
graphic card according to what kind of monitor
you have.
7
Reconnect all the cables and cords.
Step
A Note for the Fan
If the heat dissipation device provided is a fan, it
is subject to damage if not properly handled. It is
important not to put pressure on the axle or
handle the fan by the axle. A shifted axle may
shorten the fan's lifespan.
Before Installing the Driver
The product package contains the Software
Pack CD. Please read the Readme.txt file for
the latest information about the software before
proceeding with the driver installation.
1-6
6-pin or 8-pin connector
If the card has a 6-pin or 8-pin power connector located
at the edge of the board, as shown in the diagram to the
left, please connect the PCI-E power cable from the
system power supply to the 6-pin or 8-pin power
connector.
Do not handle the
fan by the axle.