Ableconn ISAT-M2SR Manual

H/W RAID 2x M.2 NGFF SATA SSD to 2.5" 7mm SATA III SSD
1. Introduction
Best Solution and Place to Install Fast Speed 2x M.2 NGFF SATA SSD as standard
2.5 inch 7mm SATA III Drive with H/W RAID Big Drive, 2Drive or RAID 1 Features!
1.1. Features
6Gbps SATA III H/W RAID Controller
o
Convert 2x M.2 NGFF SATA based SSD to standard 2.5" 7mm SATA drive
o
Supports SATA I, SATA II, SATA III Host port
o
Supports SATA hot plug and booting
o
o Supports 6Gbps, 3Gbps SATA based M.2 NGFF 80/60/42/30 mm SSD
o M.2 NGFF type 2280-D5-B B Key Socket on board
o Movable M.2 NGFF stand-off and multiple plated-holes supports type 2280, 2260,
2242 and 2230 SSD
o Supports dual-sided SSD module 1.5mm component height on the top and
bottom side
Supports H/W RAID 0, RAID1, SPAN (Big Drive) and PM (2Drives) Modes
o
o Not support PM (2Drives) Mode if SATA I or no Port Multiplier compatible SATA
Host connection
o 22 pin SATA (Signals and Power) male connector on board
2x M.2 SSD ACT LED
o
Transparent to the operating system, no driver required on Windows, Mac and
o
Linux
Hardware Jumper and Windows & Mac software GUI configure RAID modes
o
Provides Windows and Mac GUI to monitor RAID status
o
Includes 7mm height 2.5 " drive metal frame with 8 mounting holes and 4 HDD
o
screws
Compatible with 2.5" SATA drive dimension : 100.45mm x 69.85mm x 7mm
o
o RAID1 can preserve the Content of Existing SSD to Mirror SSD for data safety of
Data Disk (OS Disk not support)
o Supports operating temperature range:
2. Hardware Installation & RAID Configuration
RAID 0 Mode and SPAN mode will erase the data or metadata in your existing drives
and cause User can't utilize the data of existing drives that connected to this adapter.
0 ~
70 ºC
+ +
- 1 - 2-F128-01C