Figure 16 Ethernet Connector - Quantronix CubiScan 125 Operation And Technical Manual

Setup
CubiScan 125
crossover cable is required. Consult your network administrator, if
necessary, to determine your local cabling requirements.
Do the following to connect the CubiScan 125 to a network:
1. Route the Ethernet cable under the base so it cannot be crushed,
bent, or pulled loose.
2. The CubiScan 125 controller is located just behind the touch
screen at the front of the base. Connect one end of the Ethernet
cable to the Ethernet connector on the back of the CubiScan 125
controller, as shown below. Push the connector in until it locks.
There should be an audible snap when the connector locks.
Serial USB
Ethernet Connector
3. Insert the RJ-45 connector on the other end of the cable into the
network socket and push until it locks.
For information on the Ethernet cable pin-outs, refer to "Ether-
net (TCP/IP) Cable Pin Assignments" on page 82.
4. Use Quantronix' Qbit software (refer to the Qbit User Guide) or
the touch screen options (see Chapter 4 "Configuration") to
configure the CubiScan 125 for TCP/IP communication, or
refer to Appendix A "Communications Protocol" on page 81 for
information on the TCP/IP command protocol and setup param-
eters. Contact Quantronix if you need additional assistance.
Connecting to a Computer or Network
Ethernet
Figure 16
31