Table of Contents
Advertisement
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
.
12.6 Starting a programme
Touch the Start Pause
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g. the
door is open).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.7 Starting a programme with
the delay start
1. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
2. Touch the Start Pause
The appliance door locks and starts
the countdown of the delay start. The
display shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows .
3. Touch the Start Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start Pause
2. Touch the Delay Start button
3. Touch the Start Pause
button to start
12.8 The SensiCare System
load detection
After touching the Start Pause
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
2. The programme duration could be
button.
.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start Pause
button to
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
button
starts anyway, despite the overload. In
pause the appliance. The related
indicator flashes.
repeatedly until the display shows the
desired delay time.
again to start the new countdown.
The programme duration in
the display is referred to a
medium/high load.
first 30 seconds. In the programmes
where Time Manager is available,
during this phase the Time Manager
bars
placed below the time
digits play a simple animation. The
drum rotates shortly.
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
ENGLISH
31
button to
button
is
button to start
Advertisement
Table of Contents
