Electrolux EW7W6661S8 User Manual page 18

18 www.electrolux.com
Touch Time Manager button to reduce
the programme duration according to
your needs. The display shows the new
programme duration and a number of
dashes will decrease accordingly:
suitable for a full load of normally
soiled garments.
a quick cycle for a full load of lightly
soiled garments.
very quick cycle for a smaller lightly
soiled load (max. half load
recommended).
the shortest cycle to freshen up a
small amount of laundry.
The Time Manager is available only with
the programmes in the table.
indicator
1)
1) Default duration for all programmes.
Time Manager with steam
programmes
When setting a steam programme, this
button allows to chose three steam levels
and the programme duration is reduced
accordingly:
• : maximum.
• : medium.
• : minimum.
8.11 Child Lock
With this option you can prevent children
from playing with the control panel.
■
■ ■
■ ■ ■
■
■ ■
■ ■ ■
■ ■ ■
To activate/deactivate this option, hold
the Time Manager button pressed until
the indicator comes on/goes off on
the display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme. If
you press any button, the indicator
blinks to indicate that the buttons are
disabled.
8.12 Mode Dry
This button allows to activate or
deactivate the drying mode. When the
drying mode is activated, the button
indicator is on.
8.13 Permanent Anti-crease
This option adds a short anti-crease
phase at the end of the programme.
This phase reduces fabric creasing and
facilitates the fabric ironing.
To activate/deactivate this option, hold
the Mode Dry button pressed for 3
seconds until the indicator
on/goes off on the display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme.
This option can increase the
programme duration.
When the programme stops the display
shows ,the indicator
Start Pause led are lit. The drum
performs smooth movements for about
30 minutes to keep the steam benefit. By
touching any button the anti-crease
movements stop and the door unlocks,
the appliance proposes again the
previous set programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
comes
and the