Table of Contents
Advertisement
Cartridge Changeout
1. Shut off water supply and release the water pressure by opening up the tap.
2. Remove all packaging from the new cartridge, including any wraps or caps (if
applicable).
Replacement cartridge code for Z6 model: Puretec Z6-R.
Replacement cartridge code for Z7 model: Puretec Z7-R.
3. Rotate the old cartridge counterclockwise 1/4 turn, pull it out and dispose of it.
4. Insert the new cartridge into the filter head and rotate clockwise 1/4 turn until the
arrows on the head and cartridge align.
5. Turn on the water and check for leaks. If leaks occur, repeat step 2 & 3. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush filter for 5 minutes before use or until water runs clear.
Use Guidelines
•
Use for mains water supply.
•
Minimum operating pressure 200 kPa.
•
Maximum operating pressure 689 kPa. If pressure exceeds 500 kPa an approved
pressure limiting device needs to be fitted.
•
Do not allow exposure to temperatures below 0 °C, protect from freezing.
•
Maximum operating temperature 38 °C.
•
Nominal flow rate 9.5 Lpm.
•
This system must be installed according to local plumbing codes on the cold water line
only.
•
This system requires regular replacement of the filter cartridge to maintain proper
operation. Varying chlorine, sediment, or organic substance levels may affect
replacement frequency.
•
Be sure to change the filter cartridge at least every 60,000 litres for Z6 models and
60,560 litres for Z7 models or 6 months which ever occurs first; or whenever you
detect a change in taste, odour, or decrease in flow.
Caution: Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
8
Installation & Operation Manual
Performance Data
Copyright © Puretec Pty Ltd 2021
Advertisement
Table of Contents
