Table of Contents
Advertisement
7. Connect the braided hose onto stem adaptor, then connect to the cartridge head
assembly inlet (please note the arrow on the head indicating the direction of the water
flow). A hose extension kit has been provided if necessary, this can be used to extend
the hose either side of the system. Ensure the hose is kink free.
8. Connect the mixer tap's braided hose to the brass adaptor on the head outlet. Make
sure all fittings are tight and braided hose is kink free.
9. Restore the water supply and check for leaks. If leaking occurs then undo cartridge and
check the cartridge is seated properly.
10. Run the system for at least 10 minutes (turn on mixer tap to run cold water) to remove
carbon fines. Water may appear milky, but this is normal and is only tiny air bubbles
that will clear after a short period.
Installation Procedure
High Flow Inline Water Filter Systems
5
Advertisement
Table of Contents
