Table of Contents
Advertisement
Installation Requirements
1.
15mm (½") cold water flexi-connector to tap.
2.
Water supply pressure: 200 - 520 kPa.
3.
Water supply temperature: 0° - 38 °C (protect from freezing).
Alternative fittings may be required if being connected to anything other than 15 mm (½")
copper pipe. No electrical or drainage requirements.
Installation Procedure
1. Select suitable location that is close to the existing tap. Remember to allow access
room for changing filter and a suitable place where water spillage will not cause
damage. Location should not be in direct sunlight.
2. Isolate water supply and release water pressure by operating faucet lever. Disconnect
existing braided hose connections from the cold water line.
3. Attach non-return valve to water supply with thread seal tape. Then detach the 1/2"
DR Brass adaptor from the non-return valve, apply thread seal tape as necessary and
reconnect to the non-return valve.
4. Install filter cartridge to the head assembly (see Fig. 1 & 2). Please note the arrow on
the cartridge label indicates Undo and Install directions.
Warning: Ensuring the cartridge is in the correct lock position is critical prior to
operating the system. Not being seated in the correct position can cause the locking
tabs to shear and damage the head and/or water leakage. See Fig 2 for the correct
position.
5. Push the joint stem adaptors into the inlet and outlet of the cartridge head, ensuring
they are pushed in all the way.
6. Install system assembly by positioning it in the desired location, marking the position
of fixing holes and fixing with mounting screws (PureMix Z Series can be mounted
horizontally and vertically). Allow room for the connecting tubes and for removing the
cartridge (70 mm).
Note: Knocking the cartridge can cause the cartridge to come out of the locking
position. To limit the likelihood of this occurring it is best not to store items too close to
the system to avoid accidental dislodgement of the cartridge.
4
Installation & Operation Manual
Installation Requirements
Copyright © Puretec Pty Ltd 2021
Advertisement
Table of Contents
