Related Manuals for Watermark Puretec PureMix Z6
Summary of Contents for Watermark Puretec PureMix Z6
- Page 1 User Guide PureMix Z6/Z7 AS/NZS 3497 Licence No. WM 74617 Australian Certification High Flow Inline Water Filter System Services For correct operation & installation, it is essential to observe these instructions. JUN2021...
-
Page 2: Table Of Contents
What's Inside What's Inside Introduction ..........................2 Operation ............................3 Cartridge Replacement ......................3 Installation ........................... 3 Installation Requirements ....................4 Installation Procedure ......................4 Fig. 1 - Installation Diagram ....................6 Fig. 2 - Fitting the Cartridge Correctly ................. 7 Cartridge Changeout ...................... -
Page 3: Operation
Operation Operation The Puretec PureMix Inline Water Filter System is designed to run economically for many years, dependent on the initial installation and periodical maintenance. Flush systems for 10 minutes after any period of non-use more than 2 days. The PureMix Z6 Inline Water Filter System is designed to operate with mains water. The PureMix Z7 Inline Water Filter System is designed to operate with mains, rain, harsh and rural water. -
Page 4: Installation Requirements
Installation Requirements Installation Requirements 15mm (½”) cold water flexi-connector to tap. Water supply pressure: 200 - 520 kPa. Water supply temperature: 0° - 38 °C (protect from freezing). Alternative fittings may be required if being connected to anything other than 15 mm (½”) copper pipe. - Page 5 Installation Procedure 7. Connect the braided hose onto stem adaptor, then connect to the cartridge head assembly inlet (please note the arrow on the head indicating the direction of the water flow). A hose extension kit has been provided if necessary, this can be used to extend the hose either side of the system.
- Page 6 Installation Diagram Figure 1 - Installation Diagram Existing Mixer Tap Head Assembly Also includes Extending Kit Stem Adaptor Stem Adaptor Braided Hose Z6-R / Z7-R Cartridge 1/2" DR Brass Adaptor Non-Return Valve Minimum 70 mm Clearance COLD Note: Allow extra free space around the system to avoid accidental impact.
- Page 7 Fitting the Cartridge Correctly Figure 2 - Fitting the Cartridge Correctly Ensuring the cartridge is in the correct lock position is critical prior to operating the system. Not being seated in the correct position can cause the locking tabs to shear and damage the head and/or water leakage.
-
Page 8: Cartridge Changeout
Performance Data Cartridge Changeout 1. Shut off water supply and release the water pressure by opening up the tap. 2. Remove all packaging from the new cartridge, including any wraps or caps (if applicable). Replacement cartridge code for Z6 model: Puretec Z6-R. Replacement cartridge code for Z7 model: Puretec Z7-R. -
Page 9: Warranty
Warranty Notes Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name you can trust for viable and proven water solutions. The complete range of Puretec products are developed, refined, made to meet and exceed stringent specifications for the worldwide market. Important: Sales of products are subject to our Terms and Conditions which are available upon request. - Page 10 Warranty Warranty/Australia This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie Road, Lonsdale SA 5160, telephone no. 1300 140 140 and email at sales@puretec.com.au. This warranty is provided in addition to other rights and remedies you have under law: Our goods come with guarantees which cannot be excluded under the Australian Consumer Law.
- Page 11 High Flow Inline Water Filter Systems...