Century KD25 User Manual page 38

JA
Chapter 2 - Function Introduction
1. Copy
EN
It copies data from the source HDD to the target HDD. Please ensure you have
selected the copy mode you require before executing the copying process. Refer to
function [6.1 Copy Area] for details.
CT
Copy Process
Copied Time
Copy Result
Note:
*The Default setting is the quick copy mode "System and Files".
2. Compare
It is used to check if the data on the target HDD is identical to the source HDD after
the duplication is finished.
3. Copy & Compare
It executes the copying first, and then it compares the target copied with the source to
check the correctness of the duplication.
4. Erase
There are Quick Erase, Full Erase, and DoD Erase, totally three kinds of erasing
modes. Select the appropriate erase method when you would like to dispose or reuse
the HDDs.
Note:
*Users can go to Function "6.3 Erase Master" to select if erasing the source
HDD. The default setting is "Disable" to erase the source HDD.
*This function can be stopped while processing by pressing [ESC] for about 3~4
seconds.
３５
〈KD25/35HS〉
Copy 2047M
0:26 50% 1037M
Copied Progress %
Pass 0:58
No Bad Sector !
Total data capacity
Copied data capacity