Century KD25 User Manual page 35

3. Function Table
Function Description
To copy source HDD to multiple target HDDs. Refer to function 6.1 Copy Area for 3 different
1. Copy
copy mode selection.
2. Compare To compare data bit for bit between source and copied HDDs.
It makes
3. Copy+Compare
ensure data correctness.
4.1 Quick Erase
To erase HDD's index table only, it takes short time to execute this function.
4. Erase 4.2 Full Erase
Note: Func tion 6.3 To erase the whole HDD content.
can select to erase 4.3 DoD Erase
source HDD or
To erase HDDs three times complying with USA Department of Defense (DoD) standard.
not.
4.4 DoD EraseComp
To erase HDDs three times complying with USA Department of Defense (DoD) standard and
bit by bit to check if data is completely erased.
5. Utility 5.1 Show HDD Info.
copy first and then compare copied
5.1.1 Model Number
To show HDD's model number.
5.1.2 Version of Firmware
To show HDD's firmware version.
5.1.3 Serial Number
To Show the serial number of HDD.
5.1.4 Device Power Cycle
To show the count of HDD's turning on and off.
5.1.5 Power-on Hours
To show the total hours of HDD power-on.
5.1.6 Reallocation Event Count
It represents the count of failing to save data.
5.1.7 Off-Line Scan Uncorrectable
To show the sector volume that is uncorrectable when scanned
off-line. The mor e the uncorrectable sector volume is, the more
serious the HDD's damage is.
5.1.8 Seek Error Rate
To show the error rate of searching for data. It can represent the
damage rate of data stored in the HDD.
5.1.9 Temperature
To show the temperature of HDD.
HDD with source HDD
３２
〈KD25/35HS〉
JA
EN
CT
to