Table of Contents
Advertisement
1
Bobbin thread retaining spring
.06.06
Requirement
1.
The bobbin thread clamp spring should be guided reliably in the thread groove of the
thread catcher 3.
2.
2. The tension of the bobbin thread spring clamp should be as low as possible, but the
bobbin thread should be held reliably after the cutting operation.
Fig. 1 - 25
●
Adjust bobbin thread clamp spring
●
Adjust the tension in accordance with
thread clamp spring 1.
Control - requirement 1
●
Switch off the machine and bring the take-up lever to its b.d.c.
●
Engage and disengage the thread catcher
necessary.
Control - requirement 2
●
After the thread has been cut, sew a few stitches by turning the balance wheel, checking
whether the bobbin thread is drawn out of the bobbin thread clamp spring between the
1st and 3rd stitches. If necessary, correct the tension.
3
1 (screws 2) in accordance with requirement 1.
requirement 2 by bending side 4 of the bobbin
3 by hand and check requirement 1. Adjust if
Adjustment
3
2
1
4
1
31
Advertisement
Table of Contents
