Resetting The Microcomputer; Class 1 Laser Product - Kenwood RD-C707-S Service Manual

Resetting the microcomputer

Symptoms
Microcomputer
malfunction (the system
does not work, the
display is faulty, etc.).
Notes on transporting or moving the system
Before transporting or moving this system, take the following actions:
1 Disconnect any iPod, USB fl ash memory, or USB audio player connected to the main unit. If there is a CD loaded in
the system, remove it.
2 Press the [CDE] key and check to make sure that "NO DISC" appears on the display.
3 Wait a few seconds and then turn the system off .
en12_c-707i.indd 81
4 If there are any other components connected to the system, check to make sure they are all turned off before
disconnecting the cables.
Whenever moving the system, make sure you hold onto the main unit. The main unit may fall if you hold onto the speakers.
The marking this product has been classifi ed as Class 1. It means that
there is no danger of hazardous radiation outside the product.
Location: Back panel
en01_c-707i.indd 2
INFORMATION
Reset Procedure (Main unit only)
1 Turn off the power (press the [K] key to enter Standby mode).
2 While holding down the [H] and [STOPF] keys on the main unit, hold
down the main unit's power [K] key until the message "CLEAR ALL" appears
on the display.
Remember that resetting erases any stored information and restores the
system's default settings.
The marking of products using lasers
CLASS 1
LASER PRODUCT
Solution
C-707I
1/10/2008 9:49:39 AM
1/10/2008 9:48:52 AM
3