Attachment Of The Air Inlet And Outlet Panels - IQAir CleanZone 3020 Series Installation Manual & Owner's Manual

Attachment of Air Inlet
and Outlet Panels
Every CleanZone air cleaning system
needs to be fitted with an air inlet
and an air outlet panel.
Four different connection panels are
available:
• Panel without opening
(to be cut and adapted as
necessary by installer)
Order No. 207 30 05 04
• Panel with16" x 20" duct lip
Order No. 207 30 09 04
• Panel with 16" round duct lip
Order No. 207 30 06 04
• Panel with 18" round duct lip
Order No. 207 30 07 04
Inlet Panel
On the CleanZone 3030 the air inlet
panel is attached to the face of
V-bank micro-particle filter module.
On the CleanZone 3020 the air inlet
panel is attached to the face of the
HyperHEPA module.
Outlet Panel
On both the CleanZone 3020 and
3030 the air outlet panel can be
attached to any of the rectangular
sides (long sides)of the Motor End
Module.Maximum air flow is achieved
with the outlet panel attached to the
side of the Motor End Module.
Chapter 3
All manuals and user guides at all-guides.com
1. Place the inlet panel on the face of the
V-bank Micro-Particle module (3030) or
the face of the HyperHEPA module (3020)
3. Place the outlet panel either on the face
of the motor end module or take off a rec-
tangular side panel, attach it to the face of
the motor end module and attach the
outlet panel in its place.
2. Attach the panel with the eight special
screws supplied. Use a TORX 30 bit.
4. Attach the panel with the eight special
screws supplied. Use a TORX 30 bit.
18