Table of Contents
Advertisement
Duties of the operator
The SMA 30 BER-24.G1 and SMA 30
BER-14.G1 was designed and built taking
into account a risk analysis and careful
selection of the applicable harmonized
standards and technical specifications. It
thus corresponds to the prior art and al-
lows for maximum safety during operation.
However, the machine safety can only be effectively
implemented in practice, if all necessary measures have
been taken. It is the duty of care and responsibility of the
machine operator to plan these measures and to monitor
their execution.
The operator must in particular ensure that:
•
the machine must only be used for its intended use
(see chapter intended use).
•
the machine must only be operated in perfect working
condition and especially the safety devices must be
checked regularly for proper function.
•
the required protective equipment for the operation,
maintenance and repair staff must be available and
must be used.
•
the operating instructions must always in a good con-
dition and fully available at the machine.
•
only qualified and authorized staff may operate, main-
tain and repair the machine.
•
this staff must be instructed regularly about relevant
occupational safety and environmental protection and
know the operating instructions and the safety instruc-
tions.
•
all safety instructions and warnings attached to the
machine must not be removed and must remain legib-
le.
©
Basic safety instructions
The following instructions must be read
carefully in order to avoid accidents to
persons and / or property damage
•
Never attempt to operate the machine before you have
read and understood the content of this operation ma-
nual.
•
If you are unsure about any points, please contact
GERIMA for assistance.
•
Make sure that all persons who will be operating or ser-
vicing the machine have read and understood all the
relevant safety information.
•
Before starting the machine, the operator must ensure
that all safety equipment is properly installed and func-
tioning correctly.
•
Never use the machine for purposes other than those
specified in this manual. Never use the machine to
process materials other than those approved for use by
the machine's manufacturer. If you are considering
using the machine for an unapproved purpose, please
first contact GERIMA to request approval of your pro-
posed application.
•
Check that all electrical connections are secure and
sound. Never attempt to service or repair the machine
before it has been disconnected from the power supply.
•
Always use genuine GERIMA spare parts and acces-
sories or those that have been approved for use by
GERIMA.
If you encounter a problem or fault when operating the
machine and you are unable to solve the issue with the
aid of this manual, please contact GERIMA for rapid
assistance.
8
Advertisement
Table of Contents
