Gaggia Multix style PROFESSIONAL Instructions For Use Manual page 34

All manuals and user guides at all-guides.com
e n g l i s h
When the red warning light (C) is on, it indicates that there is no water in the boiler: if
this happens, the thermostat will automatically stop the appliance. Carry out the following proce-
dure:
a) stop your cleaning job immediately and switch off the
boiler by pressing the switch (B- Boiler)
b) discharge any pressure in the boiler through the acces-
sory you have been cleaning with by pressing the red swit-
ch (10) on the handle (9) (Fig. 23). If you are using the 10
iron, press button (22) (fig. 24).
c) switch off the machine by pressing the start button (M-
Accessories).
9
d) unplug the appliance.
e) wait a couple of minutes to allow the pressure in the
Fig. 23
boiler to decrease.
f) slightly loosen the fill-up cap (E) and wait until pressure
has been released completely.
CAUTION 22
Do not unscrew the cap (E) if the pressure inside the
boiler has not been released completely or if you
are operating the machine. When you unscrew the
cap, some residual steam may be released, so be
careful not to scorch yourself.
g) remove the fill-up cap (E).
h) pour in the adequate amount of water as indicated in
section "Preparing the appliance ready for use" (page 27).
Fig. 24
i) Tighten the cap (E).
NOTE
Under normal operating conditions, an illuminated green warning light (L) indicates
that the pressure in the boiler is within normal values. However, prolonged steam deli-
very will slightly lower the pressure in the boiler, causing the warning light to switch
itself off until the normal operating pressure is restored.
No particular action is required in this case and you may safely continue with your
cleaning or ironing job. The resistances in the boiler have been suitably proportioned
to provide immediate reinstatement of the operating pressure.
32