Sony Giga Juke NAS-50HDE Quick Connection And Operation Manual page 3

 Connect the AM loop antenna.
Connect the AM loop antenna to the AM
antenna terminals on the unit.
Pull on the cord lightly afterwards to confirm
that the antenna is firmly connected.
Notes
 Make sure to keep the AM loop antenna away
from the unit or other AV equipment as this may
produce noise in the radio reception.
 Make sure the metal leads (not the part covered
with vinyl insulation) are securely inserted into
the antenna terminals.
 Connect the FM wire antenna.
Connect the FM wire antenna to the FM
antenna jack on the unit.
FM wire antenna
Notes
 Make sure not to wind the FM wire antenna up
during use.
 After connecting the FM wire antenna, lay it out
so that it is as parallel to the floor as possible.
 Connect the DAB wire antenna (UK
model only).
With a DAB external antenna, you can obtain
a higher DAB broadcast sound quality. We
recommend that you use the supplied DAB
wire antenna only temporarily until you
install a DAB external antenna.
Connect the supplied DAB wire antenna to
the DAB jack on the unit.
DAB wire
antenna
Tip
To install the DAB external antenna (optional),
75 coaxial cable with F male type connector

(optional) will be needed.
 Connect the unit to a network.
If you have a network environment, you can
easily connect the unit to the Internet as
shown in the figure below.
 Disconnect the network cable from your
computer.
 Connect the network cable to the unit.

Continued

GB