Specifications - Sony PCM-R300 Operating Instructions Manual

The search function does not work.
/ The specified program number does not exist on the
tape. Renumber the program numbers (see page 18).
/ The program numbers are out of order. Renumber the
program numbers (see page 18).
The search function operates suddenly during playback.
/ Skip Play is on. Set the SKIPPLAY menu to "--" (see
page 20).
/ Repeat Play is on.
Press REPEAT on the remote repeatedly to turn off the
REPEAT or REPEAT 1 indicator in the display and
cancel Repeat Play (see page 14).
The tape operation buttons do not function while writing
or erasing a sub code.
/ All buttons do not work during the 9 seconds the start
ID or end ID is being written or erased (18 seconds in
long-play mode) or during the 1 second the skip ID is
being written or erased (2 seconds in long-play mode).
Wait until the writing or erasing the start, skip or end
ID finishes before operation.
Absolute time codes writing is not possible.
/ Recording began within a blank section.
Rewind the tape to its beginning, or locate the end of
the recorded portion with End Search before starting
recording.
Tape transport is excessively loud during fast-forwarding
or rewinding.
/ The noise is caused by the cassette and is not a
mechanical problem.
The tape stops suddenly.
/ The cassette is defective or damaged.
Press OPEN/CLOSE 6 and replace the cassette with a
new one.
When pressing 0 (REW)/) (FF) or =/+ (AMS),
the tape stops momentarily before starting to move.
/ This is normal and is not a mechanical problem.
The deck cannot be operated with the remote.
/ The battery is weak. Change both batteries.
The SBM indicator does not light up in the display even
though SBM is set to ON.
/ The SBM indicator lights up only during the recording
of analog input signals with a sampling frequency of 48
kHz or 44.1 kHz, not during the recording of a digital
input signal, an analog input signal with a sampling
frequency of 32 kHz, or during playback.
A particular operation cannot be done as you want.
/ Set the appropriate menu to its default setting (see
pages 19 and 20).
Additional Information

Specifications

Recording section
Tape Digital audio tape
Recording head
Rotary head
Recording time Standard: 120 minutes
Long-play: 240 minutes
(DT-120)
Tape speed
Standard: 8.15 mm/s
Long-play: 4.075 mm/s
Drum rotation Standard: 2,000 rpm
Long-play: 1,000 rpm
Error correction
Double-encoded Reed Solomon code
Tape section
Track pitch 13.6 µm (20.4 µm)
Sampling frequency 48 kHz, 44.1 kHz, 32 kHz
Modulation system
8-10 modulation
Transfer rate 2.46 Mbit/sec
Number of channels 2 channels, stereo
D / A conversion
Standard: 16-bit linear
(quantization)
Long-play: 12-bit non-linear
General section
Power requirements
Where purchased Power requirements
U.S.A./Canada 120 V AC, 60 Hz
Europe/U.K 230 V AC, 50/60 Hz
Power consumption 30 W
Dimensions Approx 432 122
(17 4 7 /
(not including rack mount adaptor)
Weight Approx 5.0 kg (11 lb)
Remote commander RM-D757 (supplied)
Remote control system
Infrared control
Power requirements 3V DC, with two size-AA (R6) batteries
Dimensions Approx 45
13
(1 /
16
Weight Approx 100g (3.5 oz) incl. batteries
325 mm (w/h/d)
12 7 / inches)
8 8
210 26 mm (w/h/d)
3 1
8 / 1 / inches)
8 16
(Continued)
EN
23