Veris Industries AA01 Installation Manual

VERIS INDUSTRIES
AA01
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
Product IdentIfIcatIon
AA01
Z2024687-0B PAGE 1
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
environmental SenSorS
©2009 Veris Industries USA 800.354.8556 or +1(0)503.598.4564 / support@veris.com
inStallation GUiDe
AA01
CO Calibration Accessory
2
IntroductIon
The AA01 CO calibration accessory is designed for field calibration of any CO
2
produced by Veris Industries, regardless of age. It comes complete with calibration
gas, a gas regulator, tubing, and fittings, which can be configured to easily calibrate
your CO device.
2
The calibration process normally takes about 5 minutes.
In general, Veris CO sensors use a time-weighting factor, which saves the lowest
2
concentration of CO measured in a selectable time period, and then use that
2
information to calculate the ambient or base level CO
allows your Veris CO sensor to improve its accuracy over time.
2
To use this instruction guide, first identify the shape of CO
Veris device (rectangular or pear), and then turn to the appropriate section of this
instruction manual for the specific instructions on how to calibrate your particular
device.
When connecting the gas regulator assembly to the gas bottle, verify there is at least
10 lbs of pressure remaining in the bottle.
sensor
2
concentration. This calculation
2
sensor inside of your
2
07091