Table of Contents
Advertisement
Using Video software
Shooting video clips
With a video camera connected to your computer you can use Smart Capture to capture video clips, as well
as play them or send them via e-mail.
To capture video clips, proceed as follows:
1
Launch Smart Capture.
2
Select Net Movie using the Switch Capture Mode button.
The image appears in the Finder.
3
Turn the camera towards the subject.
4
Adjust the image.
5
Click the Capture button to shoot a video clip (you can shoot up to 120 seconds, according to the settings
you chose in the Recording options section).
6
Click the Capture button when finished.
The Movie Player window appears, it contains the captured video clip.
7
Click
8
To end Smart Capture, click
✍
Make sure a camera is plugged to the i.LINK™ connector and turned on.
You can shoot video clips in the following formats:
Non-compressed:
- Video 160 x 120, 24 bits, max. 10 frames/sec.
- Audio PCM, 11.025 kHz, 16 bits, monophonic
Compressed:
- Video MPEG1 160 x 112, maximum of 30 frames/sec.).
- Audio MPEG1, 44.1 kHz (effective maximum equivalent to 11.025 kHz), monophonic.
A gap may appear when a rapid-moving object is displayed. However, this is not a malfunction.
to playback the images. Click
to pause,
to stop playback.
.
n N
42
Advertisement
Table of Contents
