Advertisement
Children in the vehicle
66
Weight category
II
III
Suitability of the seats for attaching ISOFIX child restraint systems
If you use a baby car seat of category 0 or 0+ or a rearward-facing child restraint system of category
I on a rear seat, you must adjust the driver's or front-passenger seat so that the seat does not touch
the child restraint system.
If you use a category I, forward-facing child restraint system, you should remove the head restraint
from the respective seat, if possible (
as far as possible, lie flat against the backrest of the seat.
Always observe the notes in the "Child restraint system" section (
system manufacturer's installation instructions.
When you remove the child restraint system you must replace the head restraints again immediately
(
page 109). All vehicle occupants must adjust their head restraints correctly before beginning the
Y
journey.
Make sure that the child's feet are not touching the front seat. If necessary, move the front seat
forward slightly (
For certain child restraint systems in weight categories II or III, this can mean that the area of use
is restricted. The maximum size setting of the child restraint system is not possible due to possible
contact with the roof.
Legend for the table:
X
ISOFIX position that is not suitable for ISOFIX child restraint systems in this weight category
and/or size category.
IUF Suitable for forward-facing ISOFIX child seat securing systems that belong to the "Universal"
category which are approved for use in this weight category.
IL
Suitable for ISOFIX child restraint systems as recommended; see the "Recommended child
restraint systems" table (
The manufacturer will also recommend a suitable ISOFIX child restraint system. For this, your
vehicle and the seat must be listed in the child restraint system manufacturer's model list. For
more information, contact the child restraint system manufacturer or visit their website.
Weight category
Carry-cot
0
up to 10 kg
up to approximately 6 months
0+
up to 13 kg
up to approximately 15 months
If you are using a child restraint system of size category C (ISO/R3), move the front seat to the highest position
3
and move the backrest to an upright position. Make sure that the front seat backrest does not rest against the
child restraint system.
15 kg to 25 kg
22 kg to 36 kg
Y
page 109).
Y
page 67).
Y
Left, right
U
U
page 109). The backrest of the child restraint system must,
Size category
F
G
E
E
D
C
Centre
U
U
page 59) and the child restraint
Y
Equipment
Rear seat left,
right
ISO/L1
ISO/L2
ISO/R1
ISO/R1
ISO/R2
ISO/R3
X
X
IL
IL
IL
3
IL
Advertisement
