Garantie - dalap A 2 HF User Manual

appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
5.1.17 This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilies, or lack of experience and knowledge, unless they have been given supervision or
instrucon concerning use of the appliance by a person responsible for their safety.
5.1.18 Children should be supervised to ensure that they do not play with the appliance.
6. Using Instrucons
6.1 Posion the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3 Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heang selector is set to one of the power sengs.
6.5 Once the room reaches the required temperature, heang element will stop working but fan also working
.Once the temperature decreased, the heang element will be working. The fan heater now starts and
stops automacally and thus keeps the room temperature constant.
6.6 Before switch off the heater, please turn the thermostat to MIN posion and turn the switch to fan posion,
let the appliance cool down for two minutes then turn off the heater and pull out the plug.
7. Cleaning and Maintenance
7.1 Before cleaning the appliance, disconnect it from the socket and let it cool down. The enclosure is easily
to get dirty, wipe it oen with so sponge. For every dirty parts, wipe with a sponge dipped in <50 °C water
and mild detergent, then dry the heater enclosure with clean cloth. Be careful not to let the water enter
the appliance inner. Don't splash water onto the heater, never use solvent like gasoline etc. to clean the
heater, in order to protect the enclosure.
7.2 Clean the cord and plug, dry and pack it in a plasc bag.
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plasc bag, put in a
packing box and st ore it in a dry, venlated place.
8. Trouble shoong:
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggesons below
EN
to see if you can solve the problem before calling the service centre.
Problem
The plug is loose, bad connecon
The heater does not operate, even when
it is plugged in and the switch,
thermostat is switched on.
No power in socket outlet
The input voltage is too high or too
The heang element glowing.
low.
Possible cause Treatment
Pull out the plug, check the connecon of
the plug and socket.
Then connect again.
Insert the plug in a proper socket.
Use power supply according to the rang
on the label.
The air inlet grill is blocked.
The switch was not put at heang
seng.
The thermostat operated.
The appliance didn't heat up, only
venlator worked.
The self reng cut-out operated.
The appliance is not stands upright.
Abnormal noise

GARANTIE

Die Dalap GmbH übernimmt die Garantie für den einwandfreien Betrieb des Gerätes bei zweckgemäßem welche auf
Konstruktions- oder Materialfehler des gekauften Gerätes zurückzuführen sind.Die folgende
Gebrauch in Übereinstimmung mit den aktuellen technischen Bestimmungen. Die Garantie umfasst alle Mängel,
Garantieerklärung gilt für das Gebiet der Europäischen Union.
Die Garantie umfasst kostenlosen Ersatz innerhalb von24 Monatenab dem Zeitpunkt des Erwerbs.
Die gesetzlich gültigen Rechte des Käufers werden nicht ausgeschlossen oder gemindert.
Ausschluss
Die Garantie gilt nicht für Mängel, die infolge von:
Mechanischer Krafteinwirkung,
Schmutz,

Transformationen,
Baulichen Veränderungen,

Schäden durch Wartung oder Reinigung des Gerätes,

Unfälle,

Keep the heater far way from arcles like
curtain, plasc bag, paper and other
things which can cover the inlet or can
be easily cover on the air inlet .
%
Turn the switch to heat seng.
Turn the thermostat and listen if there
is open/close voice. If there is no click
and the thermostat is not damaged,
the heater will automac switch on
when the appliance cooled down.
Turn the heater off and inspect the
blockage of inlet or outlet. Disconnect
the plug and wait at least 10 minutes
for the protecon system to reset before
aempng to restart the heater.
Put the heater on a level surface.
DE
8