TAD Evolution Two Owner's Manual page 6

CAUTION
・ Install the spike by fully screwing it.
Installation of Spikes
The installation surface can be securely established by using
spikes.
Screw the spikes into the three screw holes on the bottom of the
cabinet.
Installation can be performed with no rattling of the installation
surface and requiring no fine adjustment of spike heights, by
providing support at three locations.
Once the installation location is decided by referencing the
section about Choosing Where To Place The Speakers on page 7,
install the spikes and the tumble prevention spikes.
1. Screw in spikes at three locations on the bottom surface (two
in front and one in back).
2. Place spike receivers at locations where spikes will be
positioned, then place the speaker on top of the spike receivers.
3. Adjust the length of the fall prevention spikes to ensure that
there will be no rattling, then tighten them with nuts.
6
・
・
・
Installing and removing the woofer grille
This unit comes with a woofer grille that attaches magnetically.
How to install: As shown in the figure below, install so that the
magnet embedding position on the back of the grille is in the
vertical and horizontal directions.
How to remove: Pull the grille toward you to remove it as shown in
the figure below.
Please remove the woofer grille when using or cleaning this
speaker system. Also, if you apply horizontal force while it is
attached, the grille may fall.
Grille side
CAUTION
Place the speaker on top of something that would
not scratch it, such as a soft cloth, to perform
installation of the spikes.
Place spike receivers with the center indentation
facing up, as shown in the diagram below.
Using spikes without using spike receivers can
potentially leave scratches on the surface where the
speaker is installed, such as the surface of the floor.
Enclosure side