Golden Technologies PR-401 Service Manual page 48

*Models: All with
Far Infrared Heat.
47
Far Infrared Heat Only – Hand Control
• Press ON and the temperature light will turn on. Controller is pre-set to a low/medium
heat level and a 60 minute session.
• Once turned ON, it will display the session time and will count down from the pre-set
60 minutes.
• The temperature level can be adjusted by pressing the up or down arrows, up for more
heat, down for less heat.
• The time can only be adjusted when the Controller is OFF.
• Use the MODE button to set the time setting.
• Adjust your time by using the up and down arrows press while the time light is on, up
to increase time and down to set less time. Adjustments are in 15 minute increments.
• By pressing the MODE button a second time, the display will return to the temperature
setting for any future adjustments.
• After setting the desired time and temperature, the system will be ready to use when
you press the ON/OFF button. A heater light will indicate that the system is on and
working. When your session is complete the light will go off and the controller will
display your heat level.
• For your convenience, the controller will default to the previous setting upon your next
use. While it is suggested that the preset temperature, the second grade, and 60
minutes' working time is the best choice, you can set the temperature and time in
accordance with your own personal demands.
• Finally, the electrical power should be turned off after use.
* Hand Control models currently being used.
REVA_082012