GE Giraffe Blue Spot PT Lite Operation, Maintenance And Service Manual page 49

7.4.2 Mounting the System
WARNING:
To avoid patient injury, do not mount the system while a patient occupies the bed.
1. Make sure the light pipe is securely attached to the system as instructed in section 7.4.1.
2. Use the provided hex key to loosen the two mounting screws on the side of the dovetail mount
bracket (Refer to Figure 7-3).
3. Position the system on the accessory dovetail rail.
4. Secure the system to the dovetail rail by using the hex key to tighten the two mounting screws (Refer
to Figure 7-4).
Note: If you intend to plug the power cord into an accessory outlet on a microenvironment, refer to the
microenvironment manual for proper power cord connection.
5. Plug the power cord into the power inlet connector and rotate the retainer to grip and secure the
power cord and then plug it into the power outlet.
NOTE: If you intend to plug the power cord into an accessory outlet on a microenvironment, refer to
the microenvironment manual for proper power cord connection.
6. Before use, follow the checkout procedures as described in Chapter 8.
Figure 7-3
Chapter 7: Installation
Figure 7-4
49