Sharp CD-RW5000 Service Manual page 17

128
142
LIFT GEAR A
145
146
110
147
111
TRAY JOINT GEAR F
(CHANGE BOX L ASS'Y) ASSEMBLING POSITION
LIFT CAM
Assembling procedure
1. Turn the mode big gear approx. 37 degrees in the arrow direction.
2. Assemble the change box L ass'y.
Note: At this time, the tray joint gear F must be located in the position shown in figure.
Moreover, the gear must be engaged securely.
3. After assembly, return the mode big gear to the initial position.
4. Assemble the lift cam.
Note: At this time, the lift cam (No.140) must be located in the position shown in figure 17.
All manuals and user guides at all-guides.com
141
143
Scale: 2 magnifications
Figure 17
– 17 –
37°
Mark position
132
133
130
TRAY DRIVE GEAR F
102
CHANGE BOX L
Direct the recess part (trapezoidal side)
of the axis 135 in this direction.
135
144 140
TRAY JOINT GEAR F
LIFT CAM
*1: To position the axis part
*1
*2: When it is aligned as
140
LIFT CAM
Since this gear engagement is not
visually checked, verify that it does
not float when the gear box L is installed.
Scale: 2 magnifications
Note: Among 4 ribs on the
130
TRAY DRIVE GEAR F
135
TRAY JOINT GEAR F
CD-RW5000
*2
130
TRAY DRIVE GEAR F
135
TRAY JOINT GEAR F
of 135, engage it with 133.
described in *1, the hatched part
(low gear-height part of gear)
will be positioned as shown.
During assembly, make the
O part visible in this direction.
circumference, one rib alone
is provided with O.