Honda XR250 Tornado 2016 Owner's Manual page 119

22
TRIP 1 and TRIP 2
The tripmeter shows mileage per trip.
(Pressing the ADJUST button allows you to subtract
mileage from the instant the button is pressed
(page 20).
To reset
Press and hold the RESET-TRIP button for more than
1 second. The display will be "0.0 km".
To change mileage reading
The mileage reading can be changed by pressing the
UP/DOWN button.
The mileage is advanced in increments of a
P
0.1 km, each time the button is pushed.
The mileage is advanced continuously, when the
P
button is pushed and held.
(1)
(2)
(3)
or
(4)
(5)
(1) TRIP 1
(2) TRIP 2
or
(3) RESET-TRIP button
(4) UP button
(5) DOWN button
To subtract mileage
Pressing the ADJUST button starts to subtract mileage
from the instant the button is pressed. During
subtraction, the mode display will blink.
Example:
The mileage traveled by mistake as shown in the
illustration can be corrected. If the operator chose a
wrong route at the point A and realized the mistake at
the point B, the tripmeter indication can be corrected
by the following.
To start subtraction
Press the ADJUST button at point B, and come back
to point A. In this mode, the mileage from point B to
point A will be subtracted.
Point B
Point A
XR250 TORNADO