Page 1
Hand programming of the GEO40A10 Alphanumeric pager If necessary insert a battery. Now, press & hold the ‘Read’ key to switch the pager on. It will start to emit a series of beeps & you should, whilst continuing to hold the ‘Read’ key, now also press &...
Page 2
The next three screens display addresses 1 to 6 in pairs, the address enable states & the 7-digit ID’s or RIC’s. Modify these by moving to the right through each line using the ‘Read’ key and between address screens (1-2, 3-4 & 5-6), by use of the ‘Selection’...