Hand programming of the alphanumeric pager (2 pages)
Summary of Contents for scope GEO84Z
Page 1
Hand programming of the GEO84Z Alphanumeric pager Up Key Down Key Function Key Read Key Insert a battery – the pager will emit two short beeps. Press & hold the ‘Read’ key to switch the pager on. As soon as the pager displays the start-up message, press both the ‘Read’...
Page 2
The coding screens: [AAA Models up to V6] [All AA Models & AAA Models V7R or later] [Additional screen] Shown are the individual address numbers 1 to 6 for AAA models up to & including version V6 and address numbers 1 to 8 for all AA models or AAA models from V7R onwards. Also shown are the address enable state, On or Off &...
Page 3
Now save or discard your changes by selecting ‘Yes’ or ‘No’ using the ‘Up’ or ‘Down' keys. Confirm your choice by pressing the ‘Read’ key. NB: Pressing the ‘Function’ key at this point will discard all changes & switch the pager off. After saving the changes, the pager will switch off and emit 2 short beeps to indicate that the pager is ready to be switched on.