Sharp CD-K1861V Service Manual page 43

• When the turntable fails to stop.
5V
Is from 5 V till 2.5V down pulse (approx. 300 ms)
2.5V
0V
input into the IC701 pin 21 when the turntable is rotating?
Is there following voltage input on the IC701 pin 21 in the
specific state?
When the CD mechanism is moved up: 0V
In other states: 4.3V
Check IC2 pin26 the periphery.
IC701 defective.
• When turntable fails to move.
Is there following voltage input on the IC701 pin 21 in the
specific state?
When the CD mechanism is moved up: 0V
In other states: 4.3V
Is L output from the IC2 pin 26 during SEC when the disc skip
switch is pressed?
Check turntable motor and turntable mechanism.
Yes
Yes
Yes
Yes
Yes
Check the SWM3 and the wiring from the IC701 pin 21 to the
No
SWM3.
Check the MECHA UP SW and the wiring from the IC701 pin
No 21 to the MECHA UP SW.
Check the MECHA UP SW and the wiring from the IC701 pin
21 to the MECHA UP SW.
No
Check the wiring of IC2 pin 26.
No
– 43 –
CD-K1861V
OK
IC2 defective.