Power Supply - Brother P-Touch 580C User Manual

PROBLEM
1. The display stays blank after you have
turned on the machine or abnormal cha-
racters are displayed.
2. The machine does not print or the printed
characters are blurred.
3. The printed characters are not formed
properly.
4. Striped tape appears.
5. In multi-color print mode, the tape cannot
be fed after the machine's power supply
was suddenly cut (e.g. the power button
was pressed or there was a power failure)
while rewinding the tape, which caused
the rewinding gear to remain engaged.
REMEDY
Check that the AC adaptor is attached
properly.
If you are using alkaline batteries, check
that they are properly inserted.
If the batteries are low, replace them.
Hold down CODE and R keys and press
the ON/OFF key twice to reset the mac-
hine. The display and all contents of the
memory are also deleted.
Check that the tape cassette has been
inserted properly.
If the tape cassette is empty, replace it
with a new one.
Make sure that the tape cassette cover
has been closed.
If you are using alkaline batteries, they
may be low. Try using the AC adaptor.
You have reached the end of the tape.
Replace it with a new tape.
Open the tape compartment cover, re-
move the multi-color tape cassette, then
close the cover.
Turn on the power and press the FEED
key to disengage the rewinding gear,
causing the message "NO TAPE!" to be
displayed.
125