SoundCraft SPIRIT FOLIO User Manual page 9

A built-in 1kHz OSCILLATOR
provides a test tone for system tests or
aligning Tape Machines.
Press the switch to turn ON the
oscillator and feed the tone to the
MIX outputs.
Beware of accidentally sending bursts
of loud tone to the outputs ! SO
DON'T PRESS THIS BUTTON
DURING A LIVE PERFORMANCE!
See page 14
Press this switch to route the TAPE
RETURN signal direct to the mix outputs.
Adjust the level with the TAPE RETURN
LEVEL control.
See page 15
The MASTER FADERS set the final level of the MIX
outputs, and separate faders are provided for LEFT
and RIGHT. These should normally be set close to the
`0' mark if the input GAIN settings have been correctly
set.
See page 14
All manuals and user guides at all-guides.com
The TAPE RETURN jacks are an ideal place to connect
the playback of a tape machine, without using up any
of the LINE inputs.
This pot sets the level of playback signal fed either to
the MIX (when MIX is pressed) or MONITOR, when
TAPE RETN is pressed.
See page 15
Press this switch to route the TAPE RETURN signal to
the MONITOR or PHONES outputs.
Adjust the level with the TAPE RETURN LEVEL control.
See page 15
This control sets the output level to the MONITOR
LEFT & RIGHT outputs.
If HEADPHONES are plugged into the PHNS jack
the Monitor outputs are cut off, and the knob then
sets the headphone listening level.
See page 15
&