Setting Up The Projector - BOXLIGHT CP-322i/CP-634i User Manual

SETTING UP THE PROJECTOR

CAUTION • Install the projector in a suitable environment according to instructions
of the accompanying manual "SAFETY INSTRUCTIONS" and this manual.
• If you press the elevator buttons without holding the projector, the projector might
crash down, overturn, smash your fingers and possibly result in malfunction. To
prevent damaging the projector and injuring yourself, ALWAYS HOLD THE
PROJECTOR whenever using the elevator buttons to adjust the elevator feet.
Adjusting the Projector's Elevator Feet
You can use the elevator feet to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator feet is 0 to 9 degrees.
Press and hold in the elevator
1
buttons
Raise or lower the projector to the
2
desired height and then release the
elevator buttons
When you release the elevator buttons, the elevator
feet will lock into position.
As necessary, you can also finely
3
adjust the height of the projector by
twisting the elevator feet by hand
6