Table of Contents
Advertisement
GENERAL SAFETY INFORMATION AND PRECAUTIONS
READ THIS MANUAL THOROUGHLY BEFORE PERFORMING ANY WORK ON THE PRODUCT.
The manufacturer reserves the right to modify the product without notice for the purpose of introducing technical im-
provements or to facilitate production, installation and positioning. The illustrations in this manual may therefore differ
slightly from the actual product. The safety of the product and the accuracy of the instructions provided are nevertheless
guaranteed.
This manual forms an integral part of the product itself and must be kept in a safe place in order to avoid damage and to
permit rapid consultation throughout the working life of the product.
Ideally, this manual should be kept with the product where it can be consulted whenever needed. The manual should
always accompany the product if sold or transferred to a new owner, or stay with it if the owner moves house and leaves
it behind, so that the next user can consult it.
GENERAL SAFETY INFORMATION
INSTALLATION
Disconnect the product from the mains power supply before commencing any work on it.
The product must be installed in conformity to the laws and standards applicable in the country of installation.
The manufacturer's responsibility ends with the supply of the product. The product must be installed in accordance with
industry standards and with these instructions, adopting best professional practices, by suitably qualified persons work-
ing for a company that will assume full responsibility for the completed installation
The manufacturer cannot be held responsible for consequences deriving from the unauthorised modification of the prod-
uct or from the use of non-original spare parts.
b
Do not expose the product to the elements. It is not designed for use outdoors
ELECTRICAL CONNECTIONS
The controller must be installed and connected by authorized staff according to applicable regulations.
Connect the power supply to the control unit complete with bipolar switch fuses (power 230Vac 50Hz). It is essential to
connect the proper grounding.
b
The product must be connected to the mains power supply via an earth leakage breaker in accordance with ap-
plicable standards. Correct functioning is only guaranteed provided the product is used with a pump for which it is
designed. The manufacturer cannot be held responsible for the consequences of improper uses.
WATER CONNECTIONS
After delivery of the product, ensure the tightening of all nuts fixing the pipes.
Be especially careful when you are connecting the piping kit to the hydraulic module, and avoid to bend the copper pipes.
b
Installation, connections and testing must be done by qualified staff who works in accordance with the standards
and follows the instruction manual. All piping should be insulated in accordance with the law.
It is essential to respect the following precautions when using the product:
- Do not touch hot parts of the product such as the water inlet and outlet pipes. Contact with hot parts can cause painful
burns.
- Do not splash water or any other liquid over the product.
- Do not rest any objects on top of the product.
- Do not expose the product to steam from a cooking hob.
- Do not allow children or inexperienced persons to operate the product.
- Do not touch the product when barefoot or wet.
- Do not pull on the electrical cables.
- Wear protective gloves and safety shoes before handling the product.
- Before carrying out components, empty the water from the system and close the shut-off valves.
2
Advertisement
Table of Contents
