Setting-Up The Machine; Electrical Connection; Water Connection - Malber Fust WD 800 Installation And User Instruction

Libretto Malber WD 800.FH9 Mon Mar 26 17:07:13 2001

SETTING-UP THE MACHINE

Place the machine near to the connection points and ensure that it is level.
To do this, adjust the feet by screwing or unscrewing them as required.
When the machine is level, tighten the lock nuts on the feet using a spanner.

ELECTRICAL CONNECTION

WATER CONNECTION

Allow a good quantity of water to flow out of the system
until it is clear and free of impurities, especially if the
plant is new or has not been used for some time.
Connect the water inlet pipe to the valve, inserting the
filter/washer supplied. Check that the other end of the
pipe is tightened properly. Position the drain hose
between a minimum of 60 cm and a maximum 90 cm
from floor level.
N.B. To prevent siphoning, do not make the machine
drain hose connection air tight.
If the water system is not provided with a drain, use the
bracket supplied to position the drain pipe over a
washbasin then tie it to a tap.
Colori compositi
Pagina 5
Check that the power supply and socket are correctly
sized for the maximum load demand of your machine.
The power supply voltage is indicated on the rating plate
affixed to the filter door on the bottom right of the washing
machine.
The domestic power supply must be equipped with an
earth. If this requirement is not complied with, the
manufacturer will not be held responsible for any damage
or injury caused.
SM695
FIG. 4A
M I N .
6 0 C
M A X
M
. 9 0
C M
3