Washing And Drying; Drying - Malber Fust WD 800 Installation And User Instruction

Libretto Malber WD 800.FH9 Mon Mar 26 17:07:13 2001

WASHING AND DRYING

When drying, do not place plastic detergent containers in the drum. The detergent container is only used
WARNING!!
for the washing programmes.
* Press the half-load button.
* Do not press the no-drain button or the no-spin button.
* Set the drying time on the control knob.
* Select the wash programme and the required temperature.
* Set the wash programme and temperature.
* Press the 0/1-On/Off button or pull the knob in "1"-"On" position to start the programme.
* At the end of the wash programme, the machine will stop at one of the STOP positions on the programmer.
* When the drying is complete, the timer will stop on zero.
* Press the 0/1-On/Off button to switch off the power or push the programer knob in "0"-"Off" position.
* Remove the washing.
* Use dry hands to disconnect the machine from the mains electricity supply.
* Close the water supply valve.

DRYING

Fabrics previously treated with solvents or petroleum based substances must not be dried in the
WARNING!!
machine as these substances could cause an explosion.
* WARNING !! The washer/dryer will not function with the wool wash programme.
* WARNING!! If a detergent container is placed in the drum for the wash cycle, this must be removed before the
start of the drying cycle.
* Do not over dry the washing. It is preferable to leave it slightly damp, in that excessive drying could crease the
clothes and cause problems for ironing.
* The following items cannot be dried in the dryer: sleeping bags, quilts, pillows or large bed covers, as these tend
to expand during drying and would prevent air from circulating in the machine.
* The drying function can only be set when the programmer knob is on STOP
Load the washer/dryer and close the door.
1.
WARNING!! In order to obtain the best drying results, do not exceed the following load quantities:
- 2.5 kg for resistant fabrics (2 kg for very large or very small items).
- 1.5 kg for mixed and synthetic fabrics
With the right quantity loaded, the washing will move freely in the drum, it will not tangle and the result will
be that desired.
2. Set the drying time on dial.
3. Place the programmer knob on the STOP.
4. Keep the water supply valve open during the drying cycle.
5. Make sure the exhaust hose is in the correct position.
6. Plug in the washer/dryer (this must be carried out with dry hands only to avoid electric shocks).
7. Press the half-load button.
8. Press the 0/1-On/Off button or pull the programmer knob in "1"-"On" position to start the drying cycle.
WARNING!! The door will heat up during the drying cycle.
Adhere to all safety standards for protection against burns, including in the presence of glass.
Do not allow children near to the machine while it is in operation.
WARNING!! Zips and buttons may become hot.
9. At the end of the drying cycle, the timer knob will stop on zero.
10. Switch the machine off with the 0/1-On/Off button or push the timer knob in "0"-"Off" position.
11. With dry hands, unplug the machine from the mains.
12. Close the water supply valve.
13. Remove the washing.
Colori compositi
Pagina 11
SM695
.
9