If The Appliance Does Not Work; Technical Characteristics - Malber Fust WD 800 Installation And User Instruction

Libretto Malber WD 800.FH9 Mon Mar 26 17:07:13 2001

IF THE APPLIANCE DOES NOT WORK

Before calling for assistance, check that the operations described below have been carried out correctly as this
will save both time and money.
It will not start (indicator light off)
Make sure that:
1) Mains power is available
2) The plug is inserted properly in the socket
3) The programmer knob has been pulled out, or the
on/off button where fitted has been pressed (using the
washing machine).
4) The door is closed
It does not fill with water
Make sure that:
1) There is water in the supply system
2) The valve is open
3) There are no kinks in the feed hose
4) With the appliance disconnected from the mains, clean
the inlet filter between the valve and the water feed hose.
It will not drain or spin
Make sure that:
1) The drain hose is positioned correctly
2) There are no kinks in the drain hose
3) The quantity of detergent is not excessive
4) The detergent dispenser drawer is not blocked with
detergent
5) The detergent is that recommended for washing
machines
The door will not open
1) Wait three minutes after the programme has finished
Try to start the appliance again to see whether the problem
has been solved.
If the problem persists, call the service centre stating:
1) The type of problem
2) The washing machine model
3) The serial number of the machine reported on the
rating plate inside the filter door

TECHNICAL CHARACTERISTICS

DIMENSIONS
WATER PRESSURE
MAXIMUM WASH LOAD
MAXIMUM DRYING LOAD
ELETTRICAL DATA
11
Colori compositi
Pagina 13
It will not start (with indicator light on)
Make sure that:
1) The programmer knob is set on the required
programme
2) See problem "does not fill" with water
I cannot see any water during the wash
This is simply because the new technology used in
the machine guarantees double the wash with half
the water, the environment is protected and you
save energy.
I can see too much foam
Make sure that:
1) The detergent is designed for washing machines
It vibrates or is noisy
Make sure that:
1) Large items have not become tangled (sheets,
tablecloths, etc.)
2) The washing machine is properly levelled
3) The four transport screws and spacers have been
removed.
Does not dry
1) The programme has been chosen correctly
2) The water tap is turned on
3) The discharge filter is clean
4) The washing load is right
Width 59,5 cm - Height 85 cm - Dept 53 cm
0,05 MPa minimum - 1MPa maximum
5 Kg Cotton linen - 2.5Kg Synthetics,delicates - 1Kg Wollens
2.5 Kg Cotton linen - 1.5 Kg Synthetics,delicates
See plate with technical features inside the door filter
SM695
model
N ° 204276237
220 V Hz
heating wash W
kg wash
kg dry heating dryer W
2 wash motor W
5 / 100 N/cm
spin motor W
A
dryer motor W
pump W
total w
service