Epson SC-T5400 Series User Manual page 153

SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Settings item
Page Margin
Smoothing
Base Output Size
Resolution
Using the Menu
Settings value Explanation
* Select the top, bottom, left, and right margin values.
3 mm
For a cut sheet, the top, bottom, left, and right margin values are 3 mm
5 mm
regardless of the settings.
On
This setting is enabled when Resolution is set to Standard and there is no
resolution specification in the sent print data. Setting this to On will print at
*
the maximum resolution corresponding to the Paper Type setting for the
Off
paper selected in Paper Source, but depending on the data, this may result
in a long print time, or failures in printing because of insufficient memory.
* The hard clip area of the PS command of the data becomes the base output
Auto
size. The actual output size depends on the Page Margins option. When the
data does not contain a PS command, the smallest rectangle area
the following illustration including the print object becomes the base
output size.
A Series The compatible standard sizes for the selected Paper Source are displayed,
therefore select the Base Output Size. The actual output size depends on the
US-ANSI
Page Margins option.
For a cut sheet, this setting is available only when the data does not contain
US-ARCH
a PS command. If the data contains a PS command, this setting is not
available, and the hard clip area of the PS command becomes the Base
B Series (ISO)
Output Size.
B Series (JIS)
Others
User-Defined Select this option when outputting at non-standard sizes. After selecting
this setting, set Paper Width and Paper Height. You can set in 0.1 mm
increments.
The actual output size depends on the Page Margins option.
* This setting is enabled when the resolution is not specified in the sent print
Standard
data. Standard will print at the resolution corresponding to the Paper Type
setting for the paper selected in Paper Source and the Quality setting.
300dpi
600dpi
1200dpi
153
of in