Thermal Protector - Bissell CLEANVIEW 80Q2 User Manual

M
aintenance and care
Cleaning the Post-motor HEPA media filter
The post-motor HEPA media filter
assists in the filtration process to
return clean air to the room. Use only
BISSELL replacement filters in your
CleanView Multi Cyclonic.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled "FILTER" on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA media
filter by grasping the handle on the filter
and pulling out to remove.
4. Replace the post-motor HEPA media
filter with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter.
This filter is NOT washable and
must be replaced when it becomes
dirty.
5. Replace the filter door by inserting the
two tabs at the bottom of the filter door.
Then push down on the tab on the
door and push it back into the vacuum.
Release the tab on the door to lock into
place.

Thermal protector

An internal thermal protector has
been designed into your vacuum to
protect it from overheating. When
the thermal protector activates, the
vacuum motor will stop operating. If
this happens:
1. Turn the cleaner OFF (O) and unplug
from electrical outlet.
2. Empty dirt container, check filters and
air passages for dirt accumulation.
3. The thermal protector automatically
resets after approximately 2 hours. If
the thermal protector does not reset, call
BISSELL Consumer Services or visit the
website.
12
w w w . b i s s e l l . c a
3.
4.
Post-Motor HEPA
MediaFilter
1 - 8 0 0 - 2 6 3 - 2 5 3 5