BorMann BIW4005 Owner's Manual page 3

Technical Data
Rated input voltage:
Current:
Duty cycle:
Power factor:
Cutting thickness:
Protection Degree:
Installation
1) The power plug should be connected to correct voltage and not to wrongly connect voltage class. Users always connect
plug to 230V power source, but not to 380V AC power. Otherwise, it will bum and damage elements in the machine.
2) Power line and power switch should be in good contact in case of oxidation. If you have an instrument at hand, you can
check power voltage to find whether it is in the correct range or not.
3
230V/50HZ
10-40A
60%
0.73
1-12MM
IP21S"
www.BormannTools.com