Ⅳ. Troubleshooting - RHYTHM P2 Manual

Ⅳ. TROUBLESHOOTING
The table below lists some common problems and actions you can take. If you can't
resolve a problem, please contact your equipment provider.
Problem Possible Cause
Battery is not
installed correctly
Device Won't
Battery is depleted.
Turn On
The AC supply is not
connected.
The device is not
turned on.
No Oxygen Cannula is kinked or
obstructed.
Equipment failure.
The device is
Oxygen Not At
warming up.
Full
Concentration
The sieve beds may
require servicing.
Alarm Occurs Various causes
Troubleshooting
Recommended Solution
Remove the battery and re-install it
correctly.
Use the AC power adapter to operate the
device with the battery inserted to
recharge the battery. If this does not
resolve the problem, contact your
equipment provider.
Check power supply connection and
verify the green light on the power
adapter is turned on.
Turn on the concentrator.
Check cannula and its connection to the
oxygen outlet port.
Contact your equipment provider.
Wait 2 minutes for the device to warm up.
If the problem is not resolved, please
contact your equipment provider.
Contact your equipment provider to
change the sieve beds.
Refer to Alerts Section for full
descriptions
25