File - Holley MPI PRO-JECTION Installation Tuning And Troubleshooting Manual

14.4.1 File

If "File" is chosen, the following pull down menu will appear revealing the following commands on the PC screen:
1 - Load Map - Use this selection to load a previously saved Map from the hard drive of the PC to the ECU.
2 - Save Map - Use this selection to save a Map on the hard drive of the PC.
3 - Retrieve ECU Map - Use this selection to retrieve the current Map from the ECU to the PC. The key must be in the "On"
position and the PC connected to the ECU.
4 - Send ECU Map - Use this selection to send the current Map on the PC to the ECU. The key must be in the "On" position
and the PC connected to the ECU.
5 - Reset Base Map - This selection resets the ECU to the settings programmed at the factory. The key must be in the
"On" position and the PC connected to the ECU.
NOTE: A map must be loaded or retrieved into the "EEprom Programming" program before modifications can be made.
NOTE: Map modifications can be made with the PC not connected to the ECU. The PC must be connected to the ECU to
monitor, retrieve, or send information.
WARNING! Any modifications made to the engine maps should be made with the vehicle stopped in a safe location.
Changes made while the vehicle is in motion could result in a loss of power causing an accident
resulting in property damage, personal injury and/or death.
20