Table of Contents
Advertisement
3 - On the pop up menu select RUN.
4 - Type A:\SETUP.EXE in the command line box and click OK. This will begin the installation of the software. Follow the
on-screen information.
14.1.2 Windows 3.1
1 - Insert Disk labeled for Windows 3.1 and DOS into the floppy drive. Type SETUP A: or(B:) C: EEV30 and press Enter.
You may substitute another drive for "C:" which is the destination drive. You may substitute another directory name for
EEV30. When the DOS portion of the installation is completed, exit the DOS session.
2 - From the Window Program Manager menu: Select File. Select New. On the New Program Object dialog box
Select the Program Group Radio Button. Click the OK button.
3 - On the Program Group Properties dialog box: For Description type Holley EEV 3.0. For the Group File type EEV.
Click the OK button.
4 - From the Windows Program Manger menu: Select File. Select New. Click the OK button. On the New Program
Object dialog box select the Program Item Radio Button. Click the OK button.
5 - On the Program Item Properties dialog box: For Description type EEV 3.0. For Command Line type the Drive,
Directory and EEV30WIN.EXE. If you installed the software on the C: drive in the EEV30 directory then you would type
C:\EEV30\EEV30WIN.EXE. For Working Directory type the Drive and Directory where the software was installed.
For Shortcut Key leave None.
6 - Click the Change Icon button. Click Ok button on the message box that comes up. On the Change Icon dialog box,
click the Browse button. On the Browse dialog box: For Drives select the Drive onto which you installed the software.
For Directories select the Directory into which you installed the software. For File Name click on the HOLLEY.ICO file.
Click the OK button.
7 - On the Change Icon dialog box: Click the OK button.
8 - On the Program Item Properties dialog box: Click the OK button.
14.1.3 DOS Installation
Insert disk labeled for Windows 3.1 and DOS into the floppy drive. Type Install A:(or B:) C: EEV30 and press Enter. You may
substitute another drive for "C:", which is the destination drive. You may substitute another directory name for EEV30. When
the DOS portion of the installation is completed, you can start the program by typing EEV and pressing the Enter key
This software is comprised of three development tools: Mapview, Data Monitor, and EEprom Programming. Mapview displays
the main Injection Volume map and is used while the engine is running. Data Monitor provides system information while the
engine is running. EEprom Programming allows modification of the fuel and spark values used by the ECU.
The first screen you will enter will look like the following:
18
Advertisement
Table of Contents
Troubleshooting
