Table of Contents
Advertisement
FABRIC:
NEEDLES:
THREAD:
PRESSER FOOT:
Instruction Manual pg.___
Bernette
Advanced Guide Workbook pg.___
Feet-ures Unit ___pg.___
Serger Library – Tips and Tricks
Thread the serger for a 3-thread Overlock stitch using the Left Needle.
Use the Jeans Stitch
Turn the Stitch Selection Dial to "D" on the Stitch Display Panel.
Adjust the Stitch Length to 3. (You can shorten the Stitch Length slightly to fill in the
stitch as you serge.)
Attach the Right Hand Seam Guide and adjust it so that the guide is halfway between
the Left Needle and the right edge of the Stitch Finger.
Fold the fabric in half, wrong sides together, to 2" X 6".
Place the fold under the Presser Foot and against the Right Hand Seam Guide.
Slowly serge the fabric. The Looper threads will extend beyond the fabric on the
right side of the fold.
Pull the fabric flat. If it does not lay flat, move the Right Hand Seam Guide towards
the Left Needle and try again.
Press, trim and mount the sample.
3-THREAD FLATLOCK
Sweatshirt fleece 3" X 6"
80/12 Universal
2 cones of serger thread (Needle and Lower Looper)
1 cone of YLI Jeans Stitch
Standard
Specialty Stitches
in the Upper Looper.
1999 BERNINA Of America
(Upper Looper)
Section C - page 21
Advertisement
Table of Contents
