Important Safety Instructions; Model Designation - Hatco GLO-RAY GRFHS Series Installation And Operation Manual

Fry holding station
Table of Contents

Advertisement

Read the following important safety information before using this equipment to avoid serious injury or
death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical outlet
of the correct voltage, size, and plug configuration.
If the plug and receptacle do not match, contact a
qualified electrician to determine and install the
proper voltage and size electrical outlet.
• Turn the power switch OFF, unplug the power cord,
and allow the unit to cool before performing any
maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been
submerged or saturated with water.
• Unit is not weatherproof. Locate the unit indoors
where the ambient air temperature is a minimum of
70°F (21°C).
• Do not steam clean or use excessive water on the
unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by Hatco, an
Authorized Hatco Service Agent, or a person with
similar qualifications.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or
burn. Genuine Hatco Replacement Parts are
specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in Hatco
equipment.
Glo-Ray
Fry Holding Station
Form No. GRFHSM-0908
All manuals and user guides at all-guides.com

IMPORTANT SAFETY INSTRUCTIONS

G R F H S - P T X X
Figure 1. Model Designation
WARNING
FIRE HAZARD:
• Locate the unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances
are not maintained, discoloration or combustion
could occur.
• Do not place combustible items on top of the unit.
Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are
specifically designed for food holding areas. Breakage
of light bulbs not specially coated could result in
personal injury and/or food contamination.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department
at 800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
CAUTION
BURN HAZARD: Some exterior surfaces on the unit will
get hot. Use caution when touching these areas.
Locate the unit at the proper counter height in an area
that is convenient for use. The location should be level
to prevent the unit or its contents from falling
accidentally and strong enough to support the weight of
the unit and contents.
Do not place any object(s) with a combined weight of
20 lbs. (9 kg) or more on top of the unit; doing so may
subject personnel to injury or could damage the unit.
The top of the unit is not intended to be used as a shelf
for any object(s) weighing 20 lbs. (9 kg) or more.
NOTICE
Use non-abrasive cleaners only. Abrasive cleaners
could scratch the finish of the unit, marring its
appearance and making it susceptible to soil
accumulation.

MODEL DESIGNATION

Width (inches)
No Characters = Bin
PT = Pass-Through
PTT = Pass-Through Tunnel
1

Advertisement

Table of Contents
loading

Table of Contents