Factory Reset Mode - Pioneer DDJ-WEGO-K Service Manual

1

6.4 FACTORY RESET MODE

A To enter this mode, while simultaneously holding the Sampler and HOT CUE 1 buttons on the Deck A/C side pressed,
set the Power switch of the unit to ON. (Enter this mode when opening display terminated.)
Memorize Table 1 items when enter this mode.
During Factory Reset mode, the SYNC LEDs on both sides are lit. When you exit this mode, the LEDs go dark.
Note: As the execution time required for Factory Reset is extremely short, in effect, the SYNC LEDs appear to stay unlit.
1. Initial Settings
1
Color of the jog dial's illumination
2
Sensitivity of the jog dial's touch sensor
3
Jog dial's MIDI message sending interval
B 4
Illuminations mode
JOG LED color is Hanpin matter when the controller is launched after FACTORY RESET.
2. For the color valuation of JOG RGB LED
The color of the RGB LEDs of the jog dials must be set according to the color of each controller at the factory.
Press a setting button shown in the table below, according to the color of the cabinet of the controller. The colors of the
RGB LEDs of the jog dials for all decks (A/B/C/D) will be set to their standard colors (colors corresponding to the pressed
setting buttons).
C
The data for color change will be stored in memory immediately before the controller is turned off.
Note: If this setting is not performed, the color of the RGB LEDs of the jog dials for all the decks will be set to blue when
the unit is turned ON for the next time.
Color Variation on Controller
Black (DDJ-WEGO-K)
Red (DDJ-WEGO-R)
Green (DDJ-WEGO-G)
Violet (DDJ-WEGO-V)
White (DDJ-WEGO-W)
D
ex) If Press the FX3, JOG RGB LED will be changed as below.
E
F
24
1
2
No color settings for any deck
Sensitivity: 0
3 msec
Active
Table 1
Default Color (LED)
Blue CTRL A
Orange FX1
Emerald green FX2
Violet FX3
Frosty white CTRL B
Table 2
DDJ-WEGO-K
2
3
Setting Button
3
4
4