Installing & Cleaning Foam Wet Filter - Vacmaster VJF912PF 0201 Operator's Manual

INSTALLING & CLEANING FOAM WET
1
INSTALLING FOAM WET FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside down position. Follow instructions to remove
the cartridge filter on page 14.
3. Carefully slide the foam wet filter down over the filter cage making sure the cage is completely
covered (Fig. 2 & 3).
4. Place the power head onto the collection tank.
CLEANING FOAM WET FILTER
1. With the removed power head in an upside down position, carefully remove the foam wet filter
(Fig. 4).
2. Use a mild soap and water solution to wash the foam wet filter and rinse with clean water (Fig. 5).
3. Allow wet filters to air dry for 24 hours before installing onto the filter cage.
FILTER
3
2
4
15
5